Printed quickly and clips in great, have two in different sizes one for the bobos3 cable and the other for the PCVR cable. Keeps it nice and tidy

Used these to cap cables I was pulling through my loft and rood stop them getting gunked up with insulation. Taped to my fibreglass rods and pulled through nicely.

Stores everything perfect. My razor is a little bit slimmer but fits my backup nose timmer

Scaled down to fit my lawnmower and store it upright, stops it slipping down when bumped in the shed. Worked great

Printed nicely and works a treat.

Nice little fidget toy for your inner child. Printed well and went together easily.

This was quite impressively made. I printed a different persons version that was not wide enough but this fits perfect and prints pretty flawless too. thanks

Fits my super wide 59 Fifty easily. Prints well and solidly made. thanks

Great for scaring the kids and the mrs. Thats enough for me. Printed well and works perfect.

This thing is chunky, works really well though. I found that I had to steam the hat pretty well in order for it to retain the stretch better. That was with New ERA 59Fifty Caps one size is snug and next one up fits like a hard hat. All four of my hats seems to be slightly different in their fit from new.

Nice and simple design lightweight but solid enough to hold a 16oz set of gloves.

Printed great in PETG. Had some minor warping on the edge nearest the blower in my filament dryer when I went to 70 degress , but nowhere near as dramatic as my experience with PLA. Even with minor warping none of the silica beads fell out or spilled inside the dryer.

Printed great in PETG fits my elegoo spools nicely. Not too much filament needed compared to Bambu Labs version. thanks

Printed perfect and solid construction. Any chance of ones that are slightly deeper to fit boxing gloves I tried to scale z but it thickens the base too.

These are great. Had to print a few different ones to get the right fit. Dam special sizes.

This just gave me the incentive to buy more straps thanks, printed really well.

These are great. Had to print a few different ones to get the right fit. Dam special sizes.

These are great. Had to print a few different ones to get the right fit. Dam special sizes.

I just wanted a locking tilt able phone holder to get the perfect angle as my phone is a bit meaty.

Struggled to get the same two of the pieces to stick which would move around and have a knock on effect with the print head. 0.4 initial layer didnt fix it, turning the fans off for first few layers neither. Dusted of a new plate and it worked fine. Need to dial in some settings again. thanks for this