nice print! great quality! thank you for sharing. i was surprised when collecting the print from the plate since i thought brim was auto generated by the default profile but it didnt. but its just proved not necessary on a textured pei.

a bit tight but thats how press fit works. nice print and thank you for sharing.

perfect fit with sony vtc nice print. thanks for sharing!

feel quite sturdy i can trust. but the design is a bit strange to me 1. it doesnt seem right that the screw holes are slightly too big. it may have impact on heavier load. not my concern this time tho 2. only one side has screw holes. why? so how to fix the shelf? need to drill some holes on the top side of each bracket

one of the best food clips! strong and easy to use. can handle well with different thickness.

nice print. not the best clip design tho. hard to use on thicker bags

nice print. strong tension and feel sturdy

nice print! this design is smart, print fast, and effective. now im thinking if scaling it down to have smaller gap and even shorter print time

great print. the whole thing is a tank. the hinge is smooth. the snap lock is tight and my thumb hurts trying to open it in first 20 times. after that, its perfect. i rather like to have it that way than too loose. its so thoughtful to share this demo piece so we can test it before it is too late to find a problem. thank you for sharing this!

nice print. support can be removed easily. i use petg which is less strong but should do the job well in this. thanks for your sharing!

Thanks for sharing this! It has nuce finish, feel strong and 100% functional theres slight overhang issue but im fine with it support is not really necessary

nice print. sturdy and steady. no vibration on the screen (mini 2) during printing. great cable management groove. luckily i found 2 tiny screws and nuts M2.5 (previously for pi?) also works well for the mount. I prefer tilting the camera 90 degree for better view of the full motion range of the bed best design in same category! thanks for sharing

nice print. sturdy and steady. in flat surface you can easily place the bottle upside down on it. thanks for sharing

nice print. sturdy. i put pliers in it and it wont fall. the inner holder itself is already strong enough to be used alone. thanks for sharing

nice print. support easy to remove. sanding a bit to have very smooth edge. thanks for sharing this interesting model

nice print with PLA. very sturdy very smooth. i need a bigger one! thanks for sharing

nice print. perfect fit. quite sturdy. been using for a while. thanks for sharing

Nice print. Thanks for sharing. see measurements in photos

Nice print. Simple good design. Thank you for sharing this model! I can put a 3kg spool on it with lifting it up a little using a thicker rod i made https://makerworld.com/models/1877154

Nice print. Excellent work! it is already smooth before break-in or lube. the tolerance of the gears and the push fit pins are so mature. Well done and thanks for sharing your models. as i badly want a 2-wing so i modify the 4-wing please dont mind