Search models, users, collections, and posts
Waterproof Capsule
IP Report
Print Profile(15)
Standard Container, 0.16mm layer, 4 walls, 15% infill
Designer
2.1 h
1 plate
Gasket Only, Optional (TPU), 0.2mm layer
Designer
7 min
1 plate
Select-A-Size - Container 75%-200%
25.5 h
6 plates
Container - 0.28mm layer, 5 walls, 20% infill
1.1 h
1 plate
Click to see more
Open in Bambu Studio
Boost
5050
12663
1833
1 k
12.1 k
7.9 k
Released
Description
This small capsule can be used as an EDC accessory case, providing a convenient way to store and carry matches, pills, batteries, or other small items. Included in the design is a looped top, allowing you to conveniently attach to a backpack, bike, etc.
Designed so that no supports are required to print, and an optional “gasket” is included which (if printed in TPU) will allow the capsule to be watertight. Also, the top uses a “triple thread” design, allowing for the cap to be twisted on/off with an easy partial turn. As designed, the case is approximately 3 cm wide x 9 cm tall.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1833)