Nice, hefty drip tray. I needed something heavy duty for a very large houseplant. This is perfect.

Nice printed at 100% and at 200%.

Slightly flexible printed in PLA.

I was surprised by the variety of sounds produced by these fidgets. They were a big hit at Christmas.

Flawless.

Thank you for a design that uses the existing screws!

Works for 6 foot braided nylon cable or 6 foot flat plastic cable. Does not leave sharp kinks in either cable. Comfortable to hold while winding.

Printed beautifully. I am discovering many ways to thread the cable in wrong.

Easy assembly!! The cans roll down smoothly and I love the slim profile.

Sturdy fidget with very smooth, QUIET spinning! The center hubs can be popped out with a little effort, and interchange between styles. I printed 2 styles per plate in each color so I could make 4 versions with no filament color changes. Kiddos are loving these!

This profile is sturdy enough to print in PLA Silk+ that caused hinge failure with other models.

Very helpful when the BACK edge of a print is stuck!

Scaled up nicely to hold larger bandages.

I just dumped a pitcher of water into my aquarium and not one bit of gravel moved. Thank you for making life easier!

Printed beautifully in transparent PETG. Bonus points for a cap that nests onto the bottom of the case.

Perfect. Makes a great drink holder for my suitcase!! I printed just the inner ring first at 92% to test fit (a little too small for my cups) then printed the whole project at 94%. Love it!

Lovely ornate frame with 3" x 4.5" opening. The supports were tough to remove, but I like the frame enough to resize and print some larger ones.