Printed in PC. The press itself came out nice. For some reason the build plate recess was super stringy. I had to snip and cut a bunch of that excess filament out to make it clean enough for the insert to snap in. happens with PC on some print profiles for whatever reason. The key back now comes with a riveted strap that was super annoying to remove but not the author's fault. The holder protrudes though - the author should adopt the mod to rotate that part 90. none of the iron holders work well with the Weller but I ordered a Pinecil. Two areas of improvement: 1. Add some gussets or braces from back frame to build plate. The whole press nods forward in use - not surprising. The top of the frame creates a huge lever arm in relation to the single attach point at the bottom. 2. add some kind of alignment adjustment to the iron holder. the screws are hidden behind the iron so adjusting it if the iron isn't perpendicular is super annoying.

rubber band version works well!

great teaching demo

Very nice. I only wish there was a larger one fitting the H2 print bed that covered the whole city.

fits perfectly

works great and fits perfectly. definitely appreciate the plate with three in one to save time.

Quite good but a few recommendations: 1. an AMS profile to print both parts on one plate in two colors 2. a single color single plate profile for the same reason 3. the H2S comes with a grease and oil tube but there's only a space for one. it needs another.

Worked as expected. if there is a complaint it's that rarely a plastic poop comes down the chute and goes flying missing the bucket. If you extended the wall at the end of the chute just a bit further or curved it in slightly it would probably stop that from happening.

the top part is very fragile. it could maybe use a bit more infill or something to make it stronger so it doesn't get broken off