After sharing my experience with print quality issues, the community suggested investing in a filament dryer. Commercial filament dryers seemed a bit too expensive, so I turned a $30 fb marketplace food dehydrator into a DIY project. I drilled two holes on the bottom of a hdpe bucket that fits perfectly on top of the dryer. Easily houses 4 filaments, and temperature settings range from 50 to 70 degrees C. Hopefully it gets the job done.

#Questions Hey guys, my Bambu A1 came in the mail yesterday and I'm finding all the slicer settings a bit overwhelming. Does anyone have any suggestions on how to improve the print quality? I used gold silk PLA for this print and there was lots of stringing + layers weren't very smooth. I've also shown the g-code details.