printed in sunlu pla matte. looks awesome 👏🏻

Printed great! looks really nice! I scaled it up to fit a wider remote and it ended up being much bigger than expected. It used a ton of filament. I think for what it is 10% infill is overkill and I would reduce it by a lot next time.

So cute! kids loved it! I printed three of the smaller cats and used them as purge objects to reduce waste. I do regret printing the cat in black and using transparent green for the eyes as you can’t really tell the cats eyes are green. if I could do it again I would do a solid color for the eyes or print the cat not in black.

I’m so glad this exists. I put the Bror bench together and saw the original feet and thought “you’ve got to be kidding me”😆. This print allows me to put furniture pads on the bottom to protect my floors. My floors are uneven and I was able to add a modifier cube to the bottom of two of the feet to add a couple millimeters in height to make my bench level.

Awesome design! I wanted it to be a bath toy for my kid and I wanted to make sure he floated like a diver would so I made some modifications to make it more durable as a kids toy and so that it would float correctly. Added a negative cylinder to each tank so they would be hollow and did 100% infill in his chest and front of his legs so they would be heavier and 15% infill everywhere else and 4 wall loops. I think I scaled it up but I can’t remember but he is about 160mm long. I ended up changing the layer height to 0.16 and adding tree supports at a 27 degree threshold angle becasue the little tank connector piece right behind his head was not printing well (could have been a stringy PETG issue so I printed it in silent mode to slow down the print as well). My kid loves it!

Freaking awesome 👏🏻. The bees that were trapped on my screened porch thank you 🙏🐝. Printed perfectly. I Printed in PETG and I had to slow the printer to silent mode for the steeper overhang part on the handle I was getting lots of stringing and small blobs but that resolved once slowed. If I print a second one I will select “Avoid crossing wall” to help with the stringyness of the PETG and will run it in silent mode from the start.

Amazing! No issues! I printed with the “Flexi Holding cat” as a purge object and I purged into the infil on the dragon as well (and despite the purge colors being black and dark green you can’t really tell through the white outer walls unless you hold it up to the light) so even less waste and still really great quality! Printed in PETG bone white, PETG translucent teal, PETG black.

Great design! I know it’s for the self watering corm cup setup but I will be using this as a little starter pot for corms and baby plants. I like the dimensions and air flow of the pot! 🪴🌱

No issues! Very cute! printed perfectly.

great design! very efficient use of filament and print time! prieces fit together perfectly. I only printed a few of the pieces for my needs. Printed in Overture Grass Green PETG.

awesome design! super simple and it just works! no worry about breaking pieces when snapping them into place like on other tool box designs. printed in PLA.

Great! works as intended! Printed in translucent PETG.

Great! I added a magnet (you can see it on the left side) because this requires a table on the back for it to work and not fall off, and my printer is on a very small table, so the magnet makes it stay without resting on a table.

I unexpectedly had to say goodbye to my Pomeranian on Valentine’s Day (4 days ago). This print is so adorable and is bringing me joy during a very hard time. This was my 4th print ever. I hope to try it with colors at some point. Thank you for this design ❤️‍🩹🐾🦊