#Questions I am new to this world (less than 6 months). I bought a P1S during the black Friday sale with the AMS. I had set it up in the middle of December sometime and was printing away and everything was super smooth. I had a jam in the AMS with Bambu filament and now my AMS isn't recognized by my printer. I have taken it apart, checked everything for jams, checked all connections to make sure they were all plugged in and put it back together. I also changed out the 6-pin connector since I had an extra on hand. Nothing has worked. I even shut down and unplugged the printer and disconnected everything and did a hard reset on it and started over like it was new. Nothing has worked. Can anyone help me? I was going to submit a ticket, but they want a recording of what is wrong and its kind of dumb to send a recording of something that is not on. And nowhere is there a place to type the problem and all of the stuff I have tried. While i may be new to 3D printing, I am pretty good with mechanical stuff. Any suggestions would be wonderful. I don't even know if I am putting this in the correct place. Thank you. Hope