The lid did need to be resized a tad bit smaller. I think I took the length down 0.2. Otherwise good print.

The snowflake inserts aren't an exact match to the cut out. I tried on multiple printers. I was able to super glue them on, but it would be nice if they just fit right into the cut outs. I did rotate the snowflakes every way possible on all 4 sides and it was all the same. Otherwise, good print.

Great print! It would be cool to get all original 151 pokemon printed in hueforge form.

Great print. I use this for smaller hueforge prints.

Amazing print. I am actually using the cape that's 3d printed instead of using that as a template to cut a fabric cape. I did have to glue the head down a little bit because the cape is super stiff and kept popping up the head. Just a couple dabs of super glue does the trick on the inside of the head.

great print. I did print the hair standing up because if you lay it down there is a flat spot on the side.

great print!

good print. a buddy asked if I could make these. he hasn't picked them up yet but they seem well mate and we'll designed.

great print although the center pieces are a bit hard to click in. I had to use a rubber hammer.

great print. although I would add the hole to add a light on the bottom and add a hanging hole on the back for the options to put on a wall.

great print

great print

great print, made it for a friend at work

great print. I’ve made it in a few colors