Excellent model. I did not have any trouble with the inlaid trim pieces, just need to make sure that the channels are clear prior to installation. It's quite the model, with a 27.5" wingspan. I need to print this again with even darker trim pieces.

Great model of a historic warbird from WWII. I printed the 1:35 scale version with Invasion stripes. I used Army green instead of black.

I printed 100 to a plate. truly the best filament clip for Bambu Lab spools.

Excellent model. The details are great. I also had issues with landing gear axles were too small, holes for the axles were too small. I just scaled up the axles and added a negative cylinder to allow the axles to fit. Printed in Bambu Lab matte Ivory White, Bambu Lab matte Charcoal, and Bambu Lab Silk+ Titan Grey. 0.2mm nozzle, 0.08mm layer height. I combined the two wing pieces into one.

significantly quieter. Thank you for the magnetic filament cutter stopper upgrade. Printed in Polymaker ASA black on my P1S. 0.2mm nozzle with 0.08mm layers.

Another spectacular model! I have printed all the Masterbuilds now. I am looking forward to the next release.

Absolutely fantastic model. I did have a small gap between the mid section and rear section, which i will fill with plastic putty. The press-in letters and roundels needed resizing.

Excellent model to go with my A-10 collection.

Great model. Printed in matte black, matte red, and silk titan grey.

I broke my original one, my replacement should last a long time.

Excellent addition to PB94's SR-71 SNAPKIT model. The only thing that would make this better is if it had the actual tail number (17972).

Wonderful mother's day gift.

Another spectacular model. The details really reflect what a beautiful and unique aircraft this is. I appreciate your attention to detail.

Another spectacular model. The pivot pins for the rudders seemed a little fragile, so I merged the two pieces of each rudder into one piece. I am looking forward to what is next.

Really enjoying the Command and Conquer models. Keep them coming.

Another spectacular model from the Command and Conquer franchise. I look forward to seeing more.

Missing assembly instructions. Was easy to adapt to a more realistic model from the Command and Conquer franchise. Printed in Bambu Labs Silk Titan Grey, Bambu Labs Transparent Ice Blue, and CC3D Silk Sapphire Blue.

Really enjoying the Command and Conquer models. Keep them coming.

I made one for everyone's stocking last Christmas. I put a surprise in each one. Printed in silk pla.

I always hated getting attacked by these. They are great to send out in droves.