first time I printed this it worked without any spaghetti but they don't tile perfectly. two sides are thicker than the others and you can insert into them. If that was fixed so I can actually tile a whole wall with these and not need to get creative with where I place them to get full coverage this would be perfect

crazy accurate, 10/10

great design, printed nice. thank you!

used it for a Dremel 7250, worked perfectly fine. thank you!

works great, just printed some custom labels too, thanks!

not sure if it's cuz I did 0.08 later or printed in ppa but this immediately vent for me. again, not sure if it's more or the design so I gave it 5 star. thanks for leaving this for people!

a little small. they work but you can't use any large cables (HDMI, power, etc). great for 1m or shorter usb c

well done model. printed well. thank you!

worked great!

worked great, but is specifically for the P1S *without* the optional extra anti vibration feet. needed a little bit of height assistance to fit snugly once you add the few extra cm of height. great print though, pretty efficient. thank you!

solid and printed well, will also be trying a 250% scale one for larger gauge / longer cables and will report back

thanks! printed one at ludicrous (166%) - it did not turn out well lol. print at normal speed and you will have no issues