I upscale it and put a slight fuzzy skin on to make it look and feel a bit more…stony? 😆 I also added some drainage holes. It came out awesome and my family love it!

It fits 👍 Yes it’s blue. I’m trying to finish this filament and nobody sees it so… 😛

Thank you! This is the first of many more. I’m not sure if the BL bright green to black worked properly but the green to black did so I assume it did.

Thank you! Works perfectly.

Thank you so much! They fit perfectly 👍 I printed the first 3 of many. I merged the parts and changed a few settings. If anyone wants that profile let me know. I printed it on my P2S and just BL Basic PLA.

They came out great! I printed these to hold stuff after gluing. I’m impressed with how it all assembled together after it was printed in pieces 👍

Came out awesome! Printed it for Xmas crazy family and they loved it and want me to make more for next Xmas 😆

Came out perfectly! I used BL marble PLA and BL Rosewood PLA. The marble has fuzzy skin to give it a bit of a stone look and feel.

They’ve been putting in some work over the past 2 weeks and have been going strong 💪

Does the job. I wanted to try finish some rainbow filament I had. I’ll probably reprint this with a better colour choice after I give this to someone else as I don’t like the filament 🤣

Does the job well. Though I would say that if you print these, make sure you pay attention to the inside. I printed it on the fastest ugliest print and had to redo some cause the inside was a bit messed up for the filament to go through.

I still need to glue it and sand 2/3 parts but this came out awesome 👍 I’m impressed with how easily the supports came off!

So far so good. I've printed it in white PLA temporarily until I get more of the lime green filament I've already used on my printer.

Fits perfectly 👍

Bit of a defect on my print but it’s my fault. I used a 0.6mm nozzle and printed it on draft so it’s could’ve been better. I’ll probably reprint it at some stage. Fits perfectly 👍

It looks great and works! just make sure you check your print speed as some of mine screwed up and had to print a few more, but I love them. Bit of a mission to link them but once it’s done it’s good to go 👍

It’s a bit of a tight fit but once it’s in it’s in. I’ve put rubber feet on it so it has less chance of it moving. Btw there is a spelling mistake in the description on the second line. It says "(especially if on heigh shelf)" when it should be high shelf ;)

Works like a charm! Was worried about printing it in PLA and it being too brittle but luckily it didn’t break 👍 I love it so far!

Works really well. I had to print it twice though. First time I think it was going too fast and didn’t have enough detail to lock onto with the rings and the second time I printed the springs things in PETG because in PLA they break too easily. Next time I’m probably just going to print the whole thing in PETG 😆 Now I need to work out how I’m going to make my filament dryer retract when I’m unloading the filament so I don’t have to manually try roll the filament and pull the filament out of the AMS PTFE tube.