Have you been trying to print miniatures for your dnd campaign recently? Well I have and what I've seen is people use the default bambu settings for the .2 nozzle, this DOES NOT WORK, well, most of the time. I've been tuning it and so far, my success rates for minis have gone from ~10% with errors that aren't a big deal every time in that 10%, to nearly 80% with very few errors that aren't even noticable, I'm wondering if I should upload a profile for my settings so you can all try them out, I've had really good luck with it compared to the default setting. Best of all, it uses only auto Gen supports for most minis, but as always make sure areas that need it are supported and if not, paint them on. Anyway here are a few that I've made using these settings and their creator is linked below. I did not take images straight off the printer but here they are painted. https://makerworld.com/@MikeGyverMinis