DIY Desktop Atomizer Humidifier
Print Profile(2)
Description
Before printing, please ensure your filament matches the print profile.
Please ensure your build plate has good adhesion. If the build plate is greasy, it is recommended to wash it with dish soap and rinse with clean water, then spray with Povidone K30 solution or other glue suitable for your build plate.
=================================================
DIY Humidifier/Atomizer Enclosure
配套PCB open-source address https://oshwhub.com/rushairer/minions-new-year-theme-humidifie
Supports two modes: USB power only and battery power
Battery power mode: Do not solder the NC resistor
USB power only mode: Solder the NC position; C2, C3 do not need to be soldered
Three-legged inductor model: 6*8 27UH/770UH [for humidifier]
Minions model from
Chinese https://makerworld.com.cn/zh/models/758720#profileId-736960
Global https://makerworld.com/zh/models/909680#profileId-870385
Assembly diagram
Purchase a 5V atomization film, 20mm or 17mm in diameter, corresponding to the models in the two different slicing files
Purchase a 7mm diameter sponge rod, cut the length according to the size of the minion, it is recommended to buy a 200mm long one and cut it slowly
Boost Me (for free)
Boost Me (for free)
Your boost is my biggest motivation when creating, thank you
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)