AMS mini wall mount pocket style holder
Copyright Claim
AMS mini wall mount pocket style holder
Boost
34
46
17
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
5.5 h
1 plate
Open in Bambu Studio
Boost
34
46
17
0
135
44
Released
Description
A simple wall mount for AMS lite, that allows you to just slide it in , without removing the leg. Then if you need it to be on the top of desc just slide it out and use it on another location
Some holes can be used for attaching it to the wall.
I personally installed it with very strong construction double-tape
Comment & Rating (17)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
Great idea and it works as intended. I did, however at safety belt to it.
The designer has replied
0
Reply
10x
0
Reply
printed amazingly but my ams keeps falling off and landing on my printer could suggest adding a safety strap for it the ams fits nicely in it but for some reason it keeps falling off in the middle of the print a safety strap of some kind would be amazing.
but I still give 5 stars
(Edited)The designer has replied
1
Reply
thanks for the ffedback ,mine works like a charm . I will defenetly add lock feature after the holydays
1
Reply
It is strong on my setup. Still, I will design some clips.
Also if the tolerances get a little bit loose on your side You can put something between the holder and the AMS leg to lock it. As an example the manual of the printer ;)
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
printed great, but the model is a bit tilted.
The designer has replied
0
Reply
It is on purpose
0
Reply
What do you have your printer resting on top of? Does help any with the vibration?
The designer has replied
0
Reply
It is a foam and a paver. It helps but I do it with all my printers
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
not strong enough. pulls off wall.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
although this printed perfectly, the model design does not in my opinion hold the AMS light adequately as just a small amount of downward force it will fall out so I chose to not trust it. also I found that by default the supports were very difficult to remove and the area in the lower part of the print was tight but a narrow flat blad long screwdriver adequately was able to remove them. it’s a pretty big print to sac Just a minute time and material. again it printed perfectly though!
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld