Second-to-second Temperature and Humidity Meter LCD Version with No. 5 Battery Adaptor Base

家里买的几个秒秒测温湿度计LCD版都开始先后报电量低，如图所示：

Several LCD version of Miaomiao temperature and humidity meters purchased by our family have begun to successively indicate low battery as shown in the picture:

一次需要更换两节CR2032电池，纽扣电池容量较低很快又会报电量低，比较费电池，所以从某宝购买了几个电池盒，带电线，几毛钱一个。

Each time, two CR2032 batteries need to be replaced. However, the capacity of these button batteries is relatively low and the low battery warning will soon appear again, which is quite wasteful. Therefore, I purchased a few battery boxes with wires from an online store, costing only a few cents each.

安装上两节AA电池，电线正极接触纽扣电池座正极，负极接触纽扣电池座负极即可，因为这里是串联所以正负极接对即可，不需要关心接在哪一边。

Install two AA batteries, and connect the positive wire to the positive terminal of the button battery holder, and the negative wire to the negative terminal of the button battery holder. Since this is a series connection, it doesn't matter which side the positive and negative ends are connected to, as long as they are connected correctly.

最后套上一个我设计的3D打印底座即可，全程无损安装，简便快捷，最后想着把时间调回来即可。

Finally, attach a 3D-printed base that I designed. The entire installation process is non-destructive, simple, and quick. All that's left to do is to adjust the time back to the correct setting.