Simple Dry Box Inlet by Golub17

Golub17

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Drybox Inlet PETG

Designer

39 min

1 plate

4.8(5)

Open in Bambu Studio

Boost

169

Released

Description

Simple Fully Printed Bowden Tube Inlet for dry box.
Print preferably out of PETG

This is a “black hole" variant, if you are interested here is a Filament Guide Drybox Inlet variant:
https://makerworld.com/en/models/501091#profileId-416154

Here are a few mods for A1 series You could be interested in:

If you wish to replace the bowden tube all the way to drybox here is the A1 series Bowden Tube Clip:
https://makerworld.com/en/models/501039#profileId-416088

If you only wish to extent the tube you can use A1 series PTFE Connector:
https://makerworld.com/en/models/501049#profileId-416105

Suitable Cable Clips for A1 series:
https://makerworld.com/en/models/137530#profileId-149657

Full Collection of My Accessories for 3D Printers:
https://makerworld.com/@golub17/collections/1575941

Comment & Rating (10)

@unmystakable

Print Profile

Drybox Inlet PETG

Came out well. thank you!

The designer has replied

@golub17

Thanks for printing, you just accidently screwed on the nuts the wrong way on the picture 😆. I will add a assembly animation soon.

@unmystakable

Replying to @golub17 :

I just threw em on for the picture tbh...I havent installed yet. Will probably do that later today.

@JetS01

Is this good enough to maintain low humidity inside the dry box? looks good!

The designer has replied

@golub17

Of course it´s not airtight to withstand pressure changes like vacuum, but the bowden tube touching the inside is enough to make a plausible seal. You will eventually let much more moisture in just by opening the box for a few seconds. I am currently using an older version of this model (that is definitely less airtight) on my primary drybox and I have no problem having under 25% all the time (summer here is moist)

(Edited)