book-shaped box_paramatric_f3d_file/参数化书形盒f3d文件

When I discovered this SnapLock Storage Boxes (parametric), I used the model (f3d) file to create a number of interesting and useful models, including this Insta OneR storage box. I even used this box as a basis for designing a storage box for my IKEA measure tape:

As I was searching for suitable containers for my dice, I stumbled upon a book-shaped box and decided to use it. At the same time, I also decided to try parameterizing this box and publishing it.
finally I made the dice box:

and the dice-timer box:

even a box for my harddisk:

 

Please download the f3d file suffix and then modify the corresponding parameters according to the documentation file of this project to obtain a box that meets your needs.

Note:

* Height refers to the entire thickness of the box, which is the complete height when closed. Therefore, the height of the content space does not equal this value, so it's best to measure the internal space before printing.

Potential Issues:

* If the value of height is relatively small, meaning the box itself is not thick, you may encounter a situation where the bottom position becomes problematic like this:

This issue will be less severe for thicker boxes:

* If you're concerned that this might reduce the lifespan of the foldable design, you can download the file "box_paramate_arc.f3d", which adds a parameter called “back_arc_adjust” to fine-tune the curvature of the book spine section. However, please note that this parameter should be set between 0 and 10. This is an unverified parameter, so use it with caution.
* In fact, the file without this parameter can already meet the requirements of most situations.

If you have any good suggestions or modified versions, please let me know.
----------------------------------------------------------------------------------------

When I discovered this parameterized box, I used the model (f3d) file to create a number of interesting and useful models, including this Insta OneR storage box. I even used this box as a basis for designing a storage box for my IKEA measure tape.
As I was searching for suitable containers for my dice, I discovered a book-shaped box, and I decided to use it. At the same time, I also decided to try parameterizing this box and publishing it.
Please download the f3d file suffix. Then, refer to the documentation file of this project and modify the corresponding parameters to obtain a box that meets your needs.
Note:
Height refers to the entire thickness of the box, meaning the complete height when closed. Therefore, the height of the content space does not equal this value. So, it's best to measure the internal space before printing.
Potential Issues:
If the value of height is relatively small, meaning the box itself is not thick, you may find that the bottom position has this situation. For a thicker state, this problem will be much better. If you are concerned that this may reduce the life of the folding design. You can download box_paramate_arc.f3d. This file adds a parameter called back_arc_adjust to fine-tune the curvature of the book spine section. However, the value of this parameter should be between 0 and 10. This is an unverified parameter, so please use it with caution. In fact, the file without this parameter can already meet the needs of most situations.

If you have any good suggestions or modified versions, please let me know.