Sci-Fi Color Swatch Case, a modular sci-fi-inspired color swatch holder

The v1 version requires glue for assembly, and an additional v2 version is provided for those who do not want to use glue for assembly.

Can accommodate up to 11 color swatches. Textured Color Swatch 有纹理的色卡 来自 云端的风 - MakerWorld

Note

***It is recommended to print the column separately using vase mode, but you can also print it with the settings of 0 layer top, 0 layer bottom, 1 or 2 layers of walls, 0% fill, and other parts together.***

Here is a simple assembly guide for the v1 version.

take care

***The column is recommended to be printed separately using the vase mode, but you can also print it with the settings of 0 layer top, 0 layer bottom, 1 or 2 layers of walls, 0% fill, and other parts together.***

Here is a simple assembly guide for the v1 version.

1. All required parts

To prevent printing failure and facilitate assembly, it is recommended to apply glue to the printed version instead of using a skirt when printing.

2. Assemble the outer frame and top surface.

Use instant adhesive for bonding.

3. Assembling frames and columns.

After positioning, use instant adhesive to bond the column and single-sided frame. Note that only one side of the column needs to be glued, and the other side does not need to be glued.

4. Slide the connector into the frame from the end.

If your printing quality is not a problem, there is no need for additional polishing of the frame ends. You can directly combine and maintain a relatively tight feel.

5. Insert the color card and slide the other side into the connector to complete the assembly.

The color card model can be downloaded here. Textured Color Swatch 有纹理的色卡 来自 云端的风 - MakerWorld

You can also model it yourself, requiring the length and width of the color card to be within 3 * 3cm, and a hole with a diameter of 1.5cm in the center.