AR Pen

The perfect addition to any man's desk. This simple single action pen disguises itself as an AR-15 making it perfect for fidgeting and sparking conversation about your hobbies. The lower even unpins from the lower letting you break it down for easier use! Pick a color, mix and match uppers and lowers, and give your desk an upgrade!

The actuating spring for the model is the spring from a pilot G2 pen (It will require a little stretching to make it long enough to work reliably). The ink cartridge itself slides into the carrier and snaps into place. All pins in the print are meant to be made from cut pieces of filament. There are three pins in total: the latch (I find it easier to clean the holes using a small drill, use pliers to shove the filament through the latch and body, then trimming to length once assembled), the take down pin ( which I find easiest to drill, cut, and then flare an end with a lighter for easier disassembly), and the locating pin in the lower (which I super glue in place after cleaning out the hole). There is a little bit of trimming needed before gluing the lower together. Simply line up the two haves and super glue together. Slide the stock in place and glue at the proper length of pull for you. Glue the clip to the inner portion of the sight base with the dimple facing down. Position the sight on the pic rail where you like it. Slide onto the mag stand and make your friends jealous!