Spool Weight

I hit a snag while printing from my dryer box recently.  A roll was getting close to the end and was too light to remain upright/stable in the dryer box.  It was pulled off center and caused a mess – see last photo.
After googling, it was clear I needed to add weight to my almost empty spools to remain stable.  I found a few options/designs out there already, but none quite matched the dimensions I wanted for my dryer spacing and spools from splice3d.com.

I took this opportunity to work on my design skills in tinkercad and learned quite a bit from this one…and probably way over-engineered it.  After more time than I care to mention, this is what I turned out and it’s working great for me.

The design will hold 3 stacks of 37 American pennies…plenty of weight.
A retainer disk holds them in place when moving from one spool to the next.
Lastly, there are a couple of tools to help with tightening and loosening the retaining disk and cannister/lid.

Settings for my print:
PLA
.20mm layer height
20% Infill
Supports off