Search models, users, collections, and posts
Yoshi Pin
IP Report
Print Profile(1)
0.2mm nozzle, 0.06mm layer, 4 walls, 50% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
7
27
0
0
11
3
Released
Description
A pin of Yoshi.
0.2mm nozzle and AMS required. Could use 0.4mm nozzle if you scale it up a bit.
Pin hardware is required of course. I got mine at Michaels. Just glue it to the back of the tie model with a dot of super glue.
You could also glue a magnet to the back instead of the pin hardware to make it a magnet.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)