Folding Stool
Print Profile(1)
Description
Print-in-place stool.
Available in one size.
55cm.
The stools are designed so that only the small stool requires support, which I have already added manually.
0.4 nozzle
4 walls
Layer height 0.16 or 0.2
15% gyroid infill
4 top/bottom layers
Large version:
High load capacity. 150 kg should not be a problem.
Printed in PLA.
Print all parts. The seat part and the base of the large version will then be glued in place using super glue or UHU ALLPLAST glue. To do this, remove the print from the plate. Pull it slightly and glue the lid and base in the deployed position. The tolerances are chosen so that no support is needed. Due to the amount of material, it is necessary to change the filament spool once.
Small version:
High load capacity. Tested at 90 kg. No problem.
Print all parts. Remove the manual support from underneath. Now press the inner and outer rings together. Rotate them completely so that the guide pins can be released (you can hear a slight crack). Using a hammer handle, tap the inner ring on the ground to allow the seat to deploy. The space is designed so that excessive force is not required.
Once deployed, secure the floor with super glue or UHU ALLPLAST glue.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (8)