Strage purge tower H2D 🤔New to use H2D. What is happening here? Printed fine until it was time to change nozzle, then this happened..

I have made a new lid riser for the AMS with a little different solution than the wedge. Please try out and give feedback if it is ok or not :) I managed to completely kill my AMS with melting silica gel this summer. I had made the typical silica containers for installing between the feeders, and filled them with silica. I then had some cardboard spools with printed plastic rings on them inside the AMS, resulting in the lid not able to close. I believe the constant adding of moist and the heat from the sun had completely melted the silica gel and it flowed like a river down iv the AMS and covered everything with a sticky layer. This led to a new main board and power board and cables. So maybe if I had installed a riser to the lid that keeps the seal I would have been fine. At least now I have, but i have dialed down a bit on the silica gel also :P