Great design thanks for the print

Very helpful thanks for the design

Very helpful thanks for the design

Great! Thanks for the file

I’m fairly new so I’m not 100% sure if it was an error on my side but under the regular PLA mat bamboo lab filament it did not stick well it kept jamming and I had to re-print it two or three times until I use the bamboo lab petg and then it printed just fine. It came out awesome and my wife loved it. I don’t know if it was just from some of the rough edges, but that’s part of the look of the great design

My soda can got stuck in. It was unable to pull it out until after I drank it and crushed the can. I did see that somebody printed it out at 101% and I may try that next other than that print looks great.

These are super cool and a great design. Thanks for the upload.

This turned out great my granddaughter loved it. A little overboard on the color until about 20 hours to print it. Also had a lot of poop left from every layer doing three color changes sometimes.

This worked great! Thanks for the design

This looks like it’s gonna be pretty fun to play with my granddaughter

So cool! It was easy to print.

This one was hard to put together I had to cheat. And look at the photo.

Just a little small to fit what I bought off of Amazon. Could just need a little sanding and would probably work.

I love it when designs just work! Thank you

My first try at PTU it was pretty cool! Great design. And the chart for the sizes is pretty accurate. Great job.