As an enthusiastic baker and 3D printing practitioner, I required a business card display for an upcoming market event. I envisioned a unique stand mixer business card holder, and I am pleased to present the result. This design functions not only as a business card holder but also as a pen holder.

Made this beast for a friend and had to share it.

Simple easy to print Banana hanger/holder

wanted something different so I made this Brick (LEG0 Style) Joker toilet paper holder.

check this out! This highly efficient and straightforward filament spool rewinder is designed for seamless attachment to a drill equipped with a 1/4 inch or larger chuck. The design necessitates only a single 1/4 x 3.5 inch bolt (7mm x 88mm). I printed this in regular bamboo lab PLA and had been using it exclusively for some time with no issues.

Vancover Whitecaps FC Lightbox

Simple yet Beautiful Team Canada Lightbox

simple yet beautiful Arsenal FC lightbox with stand

Johnny Canuck Lightbox

My Daughter wanted a lightbox so I made her one. I turned out really nice.

Made this little lightbox holder/stand to help display my lightboxes . As you can see it works like a charm on several different lightboxes.

made this very minimalist cutting board holder to hold my boards up while not in use

I made this quick hi flow drain cover for my shower. it can be sized up or down to fit your needs. i printed it in pla plus and its been working great

I made this Simple kitchen/bathroom sink tray with drains to stop the mess on my countertop. It can be adjusted to fit your space.

Storage shelf foot/base plate support(floor saver) I made this little foot plate to protect my brand new flooring, it will for on all floor types. The idea was that the shelf foot could rest in the little slots which would enable me to slide the shelf on my carpet even while loaded.

I made this simple dresser, cabinet or desk knob in OnShape to replace a broken one on my desk. It can be scaled up or down to suit your needs. I printed it in PLA plus on the stength profile and it has lasted months without any issue.

I made this quick heater knob for my foxbody mustang, it works great and has been for 1 year. I did print this and it prints amazing, I did use ironing though that is not necessary. I would also recommend blocking supports on the small part that connects to the heater control (the shaft thing), this is not 100% needed but its easier than the clean up needed afterward. I did print this in both PETG and PLA+ but I would recommend PETG for obvious reasons pertaining to heat inside the vehicle

I made this little stopper for my toilet paper holder. This is an enlarged version of the factory roll holder stopper, the stock part was too small and the roll kept falling off. This one is sized to 29mm wide to help keep that roll in place. This model can be scaled up or down to better suit your needs.