The leaf is the difficult part to print, failed multiple times. Absolutely do not use adaptive layer

Cutted the models by 20mm, so now its 80mm wide and can fit my Creality Space Pi

Since tested this, I use 1.5 flow with 10mm/s for all bridges. Thank you so much

Tried adaptive layer, front back leg got cut off. Still can glue it back. Thanks!

Disabled support and used 1.5 bridge flow with 10mm/s bridge speed. Works wonder, thanks!

Used different build plate cleaner, simply increased the gap by 2mm and fit nicely. Thanks!

Had a difficulty printing with ABS, but still works

First time bought and use a motor, thinking more RPM equals to more power. But this need more torque. 4 star for lack of clear explanation with the mounting

Good design with terrible support

Great design and works perfectly for me. But there's slight offset on my P2S. Solved it by moving the head part by -1.1mm

5 star for the model, but does not fit on P2S

Printed the 85 degree angle, works great. Thanks!

My fault didn't check that the HEPA section is for already made cutout and not the DIY type.

45mm fits on P2S, thanks!

Scaled to 80%, perfect

Wish there was PC4 variant instead. Bit difficult to assemble

Made a custom hole to fit PC4-M6 fitting.

Had to scale up the needle cap for 1.1mm tip. Shrinkage issue with ABS

Scaled to 100mm height for bathroom shavers, works great

Scaled to 75% and used the 5mm hole for 75mm VESA. Works wonder