Search models, users, collections, and posts
Bio
Welcome to Mythic Printables—home of colourful ducks, quirky meerkats, fantasy critters and collectible characters designed for fun, reliable printing. All models are designed to print cleanly on modern FDM printers, with colour-mapped 3MF options for effortless multicolour results. If it’s cute, mythical, or just plain fun, you’ll probably find it here.
Commercial licence available through the patreon link on my profile.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
MakerLab Innovator
Export 136 models created by MakerLab
printed well, daughter loves it
Share
0
0
0
printed great, my daughter wanted it all in pink so i didn’t try colouring any specific detail
Share
0
0
0
printed great as is and my daughter loved it
Share
0
0
0
printed well, no issues, make sure you check the size of your fish food container first as I did not…
Share
0
0
0
cute little giraffe, my daughter loved it
Share
0
0
0
great design, printed well, short time and low amount of filament, many sizes to choose from
Share
0
0
0
mostly printed well, I would suggest lowering the support angle or thickening the support as the beak support broke
Share
0
0
0
great little print, one of the only flamingo models I found without brittle legs
Share
0
0
0
great print, low amount of filament given its size
Share
0
0
0
printed this twice now for my daughter and my niece, great print and colour quality and both of them loved it
Share
0
0
0
Share
0
0
0
When a 4 year old asks you to print a blue ankylosaurus skeleton, you do it. Model printed very well, very pleased, I probably would have gone with a colour closer to an actual skeleton though...
Share
0
0
0
Share
0
0
0
I printed it without the insert as we didnt need it, however the box and lid look great and fit perfectly
Share
0
0
0
Printed well, I selected supports as I thought the teeth may need it, turns out they dont and I spent 5 minutes after printing it puling the supports out from all the joins, I would recommend not printing with supports and see how it goes.
Share
0
0
0
I couldnt get the supports to hold for the mast, however, being a sunken ship it didn't affect it too much. I could not get it to sink, tried filling it with sand as well but that also didn't work. The model itself looks good.
Share
0
0
0
Fits perfectly, instructions are clear, spins to make filament change easy
Share
0
0
0
Share
0
0
0
Share
0
0
0
great print with good detail. I printed at 0.20mm, however might be better at a finer print profile to make the tops of the horns smoother as they get thinner. 0.20mm was still very good quality though.
Share
0
0
0