First, thank you for this print profile. The gen 1 MagSafe adapter fits perfectly and I appreciate the cutouts on the back side so we can easily pop the MagSafe puck out easily. However, the supports were very difficult to remove and left a lot of jagged pieces behind, especially the supports in the 4 bolt holes. Honestly, I don’t even think supports are necessary in those holes if printing with PLA. The supports for the puck section weren’t too bad though and seemed appropriately utilized.

Good print profile overall. Thank you! It has the 0.16 mm layers that the designer recommended. (Oddly, designer’s own print profile was set to 2.0 mm.) Only issue I have with this profile is the brims. They help with bed adhesion issues (if you have them) but they don’t detach easily/evenly. They leave a jagged edge that requires a lot of cleanup, which is difficult on rounded prints. I don’t think the brims are necessary with all the items in this design. but better safe than sorry I guess.