Turned out perfect!

Incredible. Just printed in 1 color, such an easy print

There were a lot of stray parts in between. I tried cleaning it up but they got warped with the heat gun... Kind of user error, but it was also too thin which caused stringing.

These turned out so well!

Printed it at 85% and it worked just fine! Such a cute little planter with minimal supports.

Turned out great! Those brims were a pain in the butt to remove though haha. Just used paint markers to bring out some details in his face. So cute!

Printed perfectly, and very easy to assemble! Did 4 on one plate no problem

Printed 2 on one plate, they both came out great! Added some silver rub n buff too.

Slapped some double sided tape on the back and put it on my coffee station. So freaking cute, printed quickly and easily!

Incredible, I loved this! Was easily painted with some acrylic paints too!

Still seems a little flimsy. Will probably increase the walls when I have to print this next

I appreciate how quickly this thing printed, definitely gets the job done easily for filament swaps on the ams lite

Very easy to print, no complaints here!

So freaking good! Scaled it up a bit (+20%) and still came out super clean. Only issue was with the bottom tip of the wing breaking off, but I blame that on my aggressive support removal.

Very minimal, just wish it had a way to "connect" to the A1. As of now it just keeps on drifting away after a few prints.

Very cute little design! I added a mildly fuzzy contour skin and randomized seams to add for a more seamless finish.

Came out super well! Had some trouble removing the supports on the wings, but it's okay since that's not really visible from the monitor anyway. I also changed the infill density to 12% gyroid to save on some filament and increase rigidity. Just colored the eyes with an acrylic marker for now, will probably use proper paint later.

Made a custom knob with the Customizer. FANTASTIC project, definitely will use this again when needed

The tips of the clamp end are a little brittle and started breaking off. I might add some sort of flared edge to them to reinforce, which could also help to lock in the cable.