I designed this 4x4 Gridfinity tray specifically for H2S maintenance accessories (There is no other available). It fits nozzle cleaning needles, 4 wiping pads, 2 wiper strips, 4 blades, grease/oil, 4 hotends with or without silicone socks, 4 extra socks, keys, and a small utility pocket. It also includes label areas for 12x22 mm Niimbot stickers, EVA foam liners for protection, and a mirrored top surface for a cleaner textured finish. Feedback and suggestions are welcome.

A simple 120° corner bracket I couldn’t find anywhere, so I modeled it. 4.8 mm mounting holes, designed to print with NO supports. Recommended: print laid on its side for best layer strength. I tested it in Bambu Lab PLA-CF and it works great. You don’t need to use every screw/hole. Avoid countersunk screws (they can split layers). Use pan/button head screws, or bolt + washer + nut.

Spotify dropped support for Car Thing, but the hardware still works—so I’m keeping it out of the landfill. With Thing Labs software + Glance Thing, it’s back as a great desk display/controller. I designed a PLA under-monitor mount that reuses the original bracket, uses one screw + double-sided tape, and has a rear fin you can gently heat/shape to your monitor’s curvature. Small reuse = less e-waste.

Just published a mini case for the LOLIN/WEMOS S3 Mini Pro (ESP32-S3, USB-C). Fast print, low material, very satisfying friction-fit, and a smooth sliding lid that ends with a clean final click when it seats. Access to screen, USB-C, and front buttons (GPIO0/47/48). Integrated LED diffuser; use translucent or light PLA to see the LED (dark filament won’t show it). Feedback on lid slide tightness welcome.