TankFu

cover

2025-11-18_16-00-04.PNG

IMG_0899.JPG

IMG_0893.JPG

IMG_0894.JPG

IMG_0895.JPG

IMG_0896.JPG

IMG_0897.JPG

IMG_0898.JPG

IMG_1075.JPEG

IMG_1076.JPEG

P1S Riser/Under-storage/Chute Drawer

Printer Accessories

KitchenAid Stand Mixer Cord Wrap

Dell Server LCD Screen Periscope

Sauce Bottle Funnel

Quick and easy print. My desk has a bevel on the underside, so I stuck a strip of cork in there to help hold it in place.

ngprint

Headphone holder modern Design

small single color Headphone Hook

I used the single-color version and colored the type with a sharpie. I need a finer-tip sharpie than I have to get the type on the edge finished as it's very small and close to an edge that would be easy to smudge.

MasterCake

Screw Bolt Nut Pitch Thread Measuring Tool M1-M10

Non-Gridfinity version

Nice design. Popped off the plate, cracked it loose, and it worked no problem. The fit on the spinner is a little tight, but I think it will loosen up as I spin it.

树果造物

双稳态陀螺-可变大变小

Bistable Gyro - Variable Size

Faster print time, same quality

This printed perfectly. I just loaded the model and printed the plate. There was a little circle of the brim inside the mouthpiece that I used tweezers to remove and it was ready to go. I didn’t need to trim or pick anything. At “.08mm extra fine” it almost looks injection molded.