Print overall is excellent, and is easy to assemble. I would suggest gluing the body and other parts (NOT The BLADES OR ENGINE NOZZLES). just makes the whole vehicle a little more sturdy. The Engine nozzles I think could be modified or adjusted a little with a "Snap in lock piece", this will still allow the engines to be rotated as needed, but also make sure they don't "Fall out" when adjusting them for Vertical Take Off or Straight Flight. Overall 10 out of 10!

Simply AMAZING model and detail, excellent print and easy to assemble. Everything snaps into place, though I would recommend some dabs of Glue to keep it there a long period of time and to make it more "Permanent". One of the top Aircraft models on Makerworld for sure! Looking forward to support his new F-15 Strike Eagle Crowdfund. Worth every penny!

Impressive model and prints great! I would suggest adjusting the Top Z Distance to a little under your layer height. So if printing at .2 layer height, Top Z on support settings should be .38 or .40 this will make the supports much easier to remove

Great print, even with PLA it worked to fix the drawers I needed... Highly recommend if you need these vs buying factory ones... save some money!

Simple, but effective poop/purge Bin. I printed 1 each for my H2 Series printers and then modified it a little for the X1C printers I have (has to be lower on the Z Axis), but it works great and is easy to dump the purge waste from printing.

Great Print, and would certainly print as many as you can fit on a plate to maximize the time and waste. No issues though...

Definitely print multiples of these on a plate to maximize waste and time and quantity. But print was great. The head was a little hard to move since I added supports, but a little wiggle here and there and it works as intended I think. You could slice this model a little higher and get to lay flat on the plate to avoid some if not all the supports needed, but this isn't necessary.

Simple, easy print, and was pretty quick too! I edited this model for my daughter for her Halloween costume with "WIB (Women in Black), and a bar-code at the bottom and she loved it...

Great HueForge print, the Bookmark is thin, but this also helps with books, so not a big deal. Its pretty large as well, so for smaller books I would suggest redoing the x and y size (don't change the Z scale as this will mess up the print).

Great Print, and I highly suggest printing more than 1 on a plate to maximize time and filament waste. Also be sure to to check the "flushing volumes and set to .8 or above for clean print results.

Printed great on X1C and H2S, the only issue is the nose cone needs some enlarging to fit over the connector, .03 at least on my testing... I would suggest either merging the cone into the body before the cut or modifying the nose clip so that it snaps on with a little glue to hold into place. Also, I would add an area to better place the stand into cause the block used to snap the top to bottom plane pieces takes up that area from what I can see.. But that could be my issue, as I haven't seen anyone say anything about that... Otherwise great model and print!

Another great Fighter Jet Model from this artist... Now to print more of his models!

amazing model, easy to assemble and print and looks great on a desk or shelf!

Easy Model to print and assemble, really like these Snap-Fit style models!

Great well thought out model... printed with no issues and was easy to assemble.