These are great! Three different pitches and SUPER loud. Great design, thanks!

This design is awesome, well done. You thought of everything.

Awesome design BUT you need a shallower blade angle. It often has trouble cutting vs my store bought one. The cutting angle on the store bought one is much shallower and works better on thinner paper. Thank you!

This model printed awesome. Great design and I appreciate the extra thought adding the screw holes for more secure mounting. I printed 3 of them.

Works well but much larger than I expected. Probably needs scaled down.

Simple and work perfectly. Saved me a trip to the store.

Great print, worked perfectly. Had to adjust the mounting holes for my needs but not a big deal.

Wonderful design, works great. 104% was the key for the Walmart 5qt Mobil1 jugs after printing 100% - 106%. PLA cracked immediately with the 100% so I switched to PETG also when I made the final 104% print. Can you make a version without the relief slots on the threaded part? I feel that weakens the design and if you scale it correctly I wouldn't think they would be needed.

Awesome design. The base prints much nicer if you print it upside down without supports. It leaves it with a much cleaner finish due to the plate contact. The largest flame (back left) is backwards and needs flipped on the plate. 500+ color changes for the dog/chair alone! The slots on the base will need minor tweaks to lengthen some of them to fit the flames properly. I used a little bit of superglue to seat the flames. Everything else seated perfect without adhesive or trimming. Would be 5 stars if the large flame orientation is corrected by default.