Printed great! I must say, starting a new print while one is still on the print bed is not a great idea! Ruined this one. I printed the single color version so I didn’t need to wait as long. Looked nice before the hinge got melted by the nozzle!

Great little design. Printed fine. I originally printed the dual color version… but then I forgot it was on the print bed and started another print. The nozzle melted a hole right through the hinge before I realized what I had done. So now I have an all black one so I didn’t need to wait as long. Fits my phone well.

Great design! Printed fine & didn’t use much filament. I’ve been trying out different phone stands and I think I’ve now printed one to leave in each room of my house (which actually means I’ve printed I think 10 different ones now). I’ll never need to worry about having a place to set my phone up!

Printed fine. Nice, satisfying click. My son is happy with it.

Printed great! My son loves it.

I absolutely LOVE Dummy 13! This print turned out great! I think he looks bummed though. Not sure why… I used a skull head for this one. BOOSTED

Printed fine, except for the “rope” that make it look like Dobby is holding the socks. It broke immediately & it just looked like some melted strands stuck together. Still worked well as a gift. I just removed the rope and sat the socks in front of him since he can’t be free without them.

Printed well. Doesn’t quite spin as long as I thought, but it does for about a minute. My son enjoys it.

Looks great! You need to be VERY careful removing the supports! I broke a small tip off & broke a piece connecting to the ring. I was able to glue the piece connecting to the ring & took a lighter to the tiny tip that broke off to make the color match. Can’t even tell now. Well done!

Looks pretty good. I think it would be a lot better with pointy tips though. More like the actual logo. Well, that version.

I changed the layer height to 0.12mm to get better details. Came out great, however I wish I would’ve known there was another version that has more sizes & ways to also measure bolt heads in the same form factor. Oh well, I’m not wasting the filament, so this will work. Feels solid.

I’ve been doing more & more design work and this really comes in handy when trying to replicate a fillet.

Of course you never know when you’re going to need it. I had some filament stuck in the lines from my AMS & needed to add the PTFE stabilizer arms but you need to remove them to feed them through the holes. Luckily I was able to get it working enough to print this & immediately made the upgrade. TLDR; Print this NOW before you absolutely need it!

These are great! I scaled them down to 75% & put them in my son’s Monopoly box. He was very surprised the next time we played!

A must have for designers! I actually end up grabbing this one more than my actual metal calipers just because this one sits on my table. I’m usually too lazy to go grab the metal one & get it out of the case unless I need to be extra precise. Usually I’m just getting a basic idea for a new idea I’m designing anyway. It’s actually more precise than I thought it would be! I would recommend it. You might want to slow down the print speed if you want perfect numbers. Mine ended up missing the hole spots defining the 6 & 9.

Great idea, but the brim is so hard to remove that I broke the tips on both ends. So I ended up with a half of each end. Still works really, just gotta be careful…

My first print I lost a support & it failed after some spaghetti, but I’m sure it’s a problem on my end. I reduced the size & printed again. It looks pretty cool with both of them.

I kind of expected it to be a little bigger, but it still looks great on my end table. Nice print.