Failed multiple times. In the end I took the file and flipped in cup upside-down. I repositioned the jandle to be flush with the rim of the cup, so it would be solidly attached to print bed. I made the hole in the base larger to reduce supports needed. It's a very fun model, I love the icecream cone vibe. But I wasted so much filamanent on failures.

I love this so much. I made the block at 100% size, and the gate at 101 so it would be a snug fit. If I did it again I would do the block at 99, and the gate at 100 so it stays on out very old plate a bit better. A very happy little boy woke me up in the early am to ask if he could take his oom gai to bed with him. I call that a win

Printed well

One of the sliders didn't stick to the bed well, but covered the flaw with the dishwasher picture

Easy to use

Very detailed. To point broke off the tippy top, but I think that was user error more than the print profile

Slicer complained that something was floating/not connected. I ignored the warning and it was okay.

Printed in green and orange. Painted the tan and dark green accents

Very solid :)

Fun little model. Sturdy, no weak points, should handle a little bit of rough and tumble from the children