Worked great. I used bambu labs ABS. Was nervous about the magnet orientation. Turns out it was not that hard. OP did a great job explaining that. Thank you.

I finally found the scaled percentage for 20g of coffee. It’s scaled to 58 percent. Fill the thing full and run the excess off with your finger. Almost perfect every time.

Worked great. Only figured out after coming back to leave this rating that you do not have to poke holes in the sandpaper to get the screws through. You just make sure there’s enough paper to get the flat bit over enough to hold it down. 🤦‍♂️

Works perfect. Printed in pla tough +

Printed great for me on the p1s using elegoo rapid petg. Thanks!