Very nice design and once I got it to work it looks very good with a few issues that could be due to my printer. All filament was Bambu matte PLA. I had real issues with bed adhesion, especially for the smaller snowflakes. I needed to completely clean my smooth bed of all glue using dish soap followed by rubbing alcohol, bumped the bed temp to 60 °C, and slowed the first layer by half. Even so, the small flakes were pretty blobby and ended up as gaps in the cover. I used arcane line gen because it's worked for me for this sort of thing in the past and was suggested in the introduction. The snaps were also very loose, I needed to mush each one quite a bit with pliers. If anyone else needs to do so, put a couple sheets of paper in between to prevent discoloration from the pliers on the other side.

Looks great!! I used silk purple, silver, and 3 color.

Printed this for my mom before surgery, and she loved it!