Very nice detail and came out great with 5 colors and PLA Support material. That said, even with PLA support material, getting the block off the front of the 1/24 scale car was terrible.

Printed in clear PETG so I could see the blue indicating beads. Fit perfect.

Cool print. I still need to sand the translucent tube to make it slide in a bit smoother.

Nice quality printed at .12 layer, took 18 hours. I printed without supports and you can see that the nose does struggle a bit on a P2S, but I was able to trim the hanging part and it still looks great.

I put all the tall parts on one plate for an overnight print and then finished up the other parts in the morning. The connecting rods are way too big when printed with a .4 and a .6 nozzle with Bambu PLA. I ended up putting them in a drill and sanding them down until they fit the sleeves.

Printed in translucent using the standard print profile. I sanded the outlet side where the two come into one. Note for putting it together, make sure you don't push one of the two input tubes in too far or it blocks the second filament from getting past.

This was a really cool build, I ended up reprinting the outside of the top part that flips up on a smooth plate.

Printed as a black cat with leather pillow and book. My sister loved it, great print!

Really nice detail, super easy to put together, 6 stars

Came out great, even with the happy little accident having the cowl upside down on the outside engines. Very nice quality, ended up printing with a .6 for most parts and .2 for some of the more detailed stuff. Light Grey, Grey, Red, and Silk Silver PLA

Second time printing, this time for the larger marker inserts. Decided to try PLA Silk and it looks amazing! My sister thanks you for the design.

Beautiful. Printed in PLA with a .2 nozzle and the artwork came great. Wrapped it in a light beige snapframe

I had to use the second plate, the first one turned into Spaghetti on my P2S printing PLA with a .4 nozzle. The alternative orientation came out great though! I don't have a picture of the good one because my sister grabbed it before I could even get my phone, she loved it.

Very cool print! The front and rear bumpers took some patience but eventually I prevailed. Great job OP

Printed with PLA at .2 nozzle, and the detail is amazing. I switched Blue to Red to match my dad's car, then I wrapped with with a Snapframe. Your other models also look good and I've got the Vette lined up next