Perfect stems and roses. Thank you. 🌹

Very cute and prints well overall, there was some layer issue in the bowl that happened each time I printed it, but nothing major and still looks great! Thanks!

Works perfectly fine and neatly winds the filament on a new spool. Well done and thank you! Boosted!

Does the job perfectly and came out great! Printed in transparent PETG and looks awesome!

Wonderful print and everything came out perfect. I printed these in transparent filament so that I could see the desiccant better and cause it matches the AMS 2 Pro better in my opinion to keep the transparency going ☺️ Thank you!

Very cute and came out great! If printing in color, I suggest printing multiple copies on the same build plate to save on waste. Thanks so much for this!

Truly beautiful design and easy to print in a short time. Well done and thank you!

Very detailed and beautiful print. Overall it works well. I do have an issue with the steel ball not always coming out from the wheel and through the mill roof and sometimes I need to tap it to roll down, but it could be that I have an issue since I printed all the wood parts in actual Bambu PLA Wood. A word of warning when printing wood that the tolerances and alignments might be slightly off. For example, I needed to carve all supports of the tracks as they would not properly go all the way inside the tower holes and the other wood structure holes, which is essential for proper track alignment & angle. I needed to manually drill the holes of the track supports as the pins were fitting too tight and breaking. Had a bit of stringing on the PLA Wood filament even with a brand new roll, so take care to properly dry it if you are printing the wood parts in actual PLA wood, as there will need to be post processing done! Thank you for this and for your hard, detailed work! Boosted!

Wasn't perfect and there are some imperfections in some layers no matter which filament is used but overall these are nice, so still 5-stars!

Great design and profile and very cute! Printed 2 of these on my H2S in around 20 hours but worth it! Just be warned that there is quite a lot of waste (200g or so when I printed 2 of these including the poop and prime tower) on the H2S and any printer with a single nozzle and multi-colour unit and the waste will be the same amount of purges between color changes even if you print 1, so ideally you print as many as you think you will need in 1 job so that you "save" more from the waste with the drawback that printing time will increase the more copies you have. Take extra care when removing the supports under the wings as the wing points are very delicate.