needed this in a hurry, was able to print and get back to glue up

works as expected.

printed well

works well, printed fine.

good model, only ask for is to somehow strengthen model for when3 HT’s are added. Latteral support is spot on, vertical support needed esp for front span.

good model and simple solution. if you add counter weigh to AM4sx this no longer fits. otherwise recommended

highly recommended if you are looking to move AMS’s of the printer. Good design, locks together very well.

holds the splinters firmly in position, cannot ask for anything more. Nice model.

prints nicely and utilized the full width of the bed. no complaints, I would recommend

works well, simple but that’s what’s needed

prints great, can’t complain. plenty of size options to fit the wall

printed perfect in PLA-CF annealed for 60 mins at 100C and now good for all filaments. much more stable than the single side

worked fine, printed last cm of feet in TPU for AMS to add some nonslip

works well, as described

worked nice, simple but nice rim.

printed in ASA, which seems to have shrunk, model works well though and will probably print in PLA-CF and anneal.

absolutely love these, big hit at Christmas with all the presents. Wife really liked these, and the cats like them as well.

worked well, used a surprise inset on printed cards.

parts fit snugly, cannot complain would recommend if you need a simple solution

works, good fit no complaints, wish I could say the same for the hex drivers