Search models, users, collections, and posts
Layer__Lab__Customs
@Layer__lab001
0
Followers
0
Following
0
3
22
1
Social Media Links
Bio
3D printing enthusiast
Pinned Models
SG 90 Servo mount
SG 90 Servo mount
2
0
9
0
Battery case for 3.7 v battery charging modules
Battery case for 3.7 v battery charging modules
1
0
1
0
7 pin 0.96 oled case
7 pin 0.96 oled case
0
0
6
0
Recent Models
Harrow farming model
Harrow farming model
0
0
6
1
Raspberry PI 4 Model B Case
Raspberry PI 4 Model B Case
0
0
0
0
SG 90 Servo mount
SG 90 Servo mount
2
0
9
0
Recent Article
Battery case for micro lithium batteries
Battery case for micro lithium batteriesWhile working on a compact robotics project, I ran into a familiar challenge—how to safely and cleanly mount a 300mAh LiPo battery along with its TP4056 charging module without leaving exposed wires and boards dangling. So I fired up Fusion360 and started designing a custom-fit 3D printed battery case that would solve this neatly. After a few test prints and tweaks, I landed on a compact enclosure that not only holds the battery and charging board snugly, but also offers USB access, wire routing, and a secure lid—perfect for quick swaps or permanent installations. I printed it using high-quality PLA for sharp edges and reliable strength. The result? A professional-looking, plug-and-play battery module that fits seamlessly into my builds. This little case might be small, but it packs a lot of practicality into your electronics game. 💡 📦 Now using it in my wearable sensor nodes and micro robotics kits!