Search models, users, collections, and posts
Bio
Woodworker, electronics creator, dad.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Popular Model
1 model more than 5,000 successful prints.
Pioneer Maker
Print successful 159 different models and 2,456 hours
The Honeywell HCM350 is a good humidifier. I have two! But the tank lid is very difficult to grip, and it took too much effort to open (and re-tighten) every time I needed to refill it.
So I took a few measurements and printed a wrench for it. It's extremely simple and effective. I used PETG-CF for strength, but I'm pretty sure it would be fine in normal PLA.
The wrench tucks neatly above the water tank when not in use.
Humidifier Water Tank Wrench
4
11
Share
0
0
0
No more data