After I broke my PTFE tube bracket (clip pin) due to putting a little too much stress on the PTFE tube, I wanted a better and, above all, stronger bracket attachment. That's why I redesigned this small, handy piece. 23 min print and 3g filament. NO more stress on the bracket :-). There is a new and improved version : https://makerworld.com/en/models/2750568-x2d-and-p2s-ptfe-tube-bracket-protecter-v2#profileId-3051650

After I broke my PTFE tube bracket (clip pin) due to putting a little too much stress on the PTFE tube, I wanted a better and, above all, stronger bracket attachment. That's why I redesigned this small, handy piece. 23 min print and 3g filament. NO more stress on the bracket :-) There is a new and improved version : https://makerworld.com/en/models/2750568-x2d-and-p2s-ptfe-tube-bracket-protecter-v2#profileId-3051650

I wanted to remove the PTFE bracket, but it was stuck tight with the 'clips', which I eventually had to cut off. So I felt that this was a problem that needed to be solved. The new design had to be better and smaller, but at least as strong and useful! After a bit of brainstorming, I present V2 to you. Smaller, easier, and stronger.

After I broke my PTFE tube bracket (clip pin) due to putting a little too much stress on the PTFE tube, I wanted a better and, above all, stronger bracket attachment. That's why I redesigned this small, handy piece. 23 min print and 3g filament. NO more stress on the bracket :-).

Designed the original ( and copied :-( by others ) toolheadcover holder for the P2S... So I did it again for my new X2D :-).

made the space 1999 osprey, did promise to make extra's. 1ste extra ready : The Booster kit ( https://makerworld.com/en/models/2298266-boosters-for-space-1999-osprey#profileId-2508159 )

made the Space 1999 Osprey ( https://makerworld.com/en/models/2244711-space-1999-osprey#profileId-2443872 ) and and promised to design more for it. See here: Booster pack

I printed a great sanding block from Makerworld, but I missed a universal tool that cut the sandpaper to the right width in one go. So I made one myself :-).

After years of use, the mounting plates on my Bticino Magic series sockets broke. Unfortunately, they're no longer available, so I designed and 3D-printed them myself. The result is fantastic, stronger than the original :-) and a perfect fit.

big fan of space 1999, specialy of the eagle one transporter. So I design a variant of it : The Osprey

Since the early days of Space 1999, I've been a huge fan of the Eagle One, the iconic spaceship. After building a few eagles, it was time to design and draw a model myself that had all the features of that iconic model: the cockpit, the tubular frame, side boosters, and the extra-large rear boosters. So, with some pride, I present to you: The Osprey (it had to be a bird name, just like the eagle is one).

I'm a big fan of 3D printing models, especially Star Wars, BGS, etc. But I never found a stand where I could pose the models so they looked dynamic. So I made my own stand that (so far) fits all my models.