It turned out well. The controller I used had up as right and down as left, but I think that was just the controller. As for the car, most of it worked well but the but the back part broke a few times and I just decided to use Duct tape. It might have turned out better if I printed in PLA rather than PETG. The steering rod could be a little thicker and have more teeth, but it still steers well. All in all, it turned out to be a good first Cyberbrick project.

A couple parts failed by it all in all it turned out well. I made it for my brother and made 6$. Cool print.

its twists were really smooth and it printed well

It snapped together really easily and I love the bevel gear for turning the gun.

I printed 6 and 4 turned out well, but two broke from small size and supports.

very flexible and is a clean print

It is really flexible. I did two prints and they both turned out perfectly.

there are no errors in the design and it works how it supposed to

The joints are a little loose, but that's expected with 3d printed action figures.