Your Plaque

A flat plaque with embossed or embedded multi-line text, an optional accent stripe wrapping around the side wall, and an optional keychain hole. Customize the text, the font, the size, the colors, and the shape.

What you can change

Click Customize on this page to open the editor.

• Size & shape — square or rectangle, 30–120 mm wide, up to 180 mm tall, 1.5–6 mm thick.
• Corners — rounded outline (0–10 mm radius) + softened top/bottom 3D edges.
• Text — single or multi-line (use * to start a new line, e.g. Name*Phone*Email).
• Font — picker from MakerWorld's full font catalog.
• Colors — each zone (body, stripe, front text, back text) has its own picker. Defaults are clean black & white; mix freely.
• Content placement — raised on top (you can feel it), flush with the top face (smooth), or embedded on the back (smooth both sides). Enable both sides for a double-sided plaque.
• Accent stripe — optional horizontal stripe wrapping around the side wall.
• Keychain hole — off by default; toggle on with diameter 3–10 mm and your choice of corner.

Print settings

• Filaments: 2 by default (body + accent). Up to 4 if you customize each color independently. Single color works too.
• Layer height: 0.2 mm recommended.
• Supports: none.
• Infill: 15% is plenty.
• Estimated print time: 25–45 minutes at the default 70×50 mm size.

In Bambu Studio / OrcaSlicer / PrusaSlicer, import the 3MF and assign filaments to each colored body. The slicer plans the swaps automatically.

Tips

• Flush modes (front flush, back enabled) make a sleek plaque with no surface bumps. The text is part of the bulk material — slightly more durable than raised text that can chip.
• Double-sided — enable both front and back to put text on both faces. Back text is mirrored so it reads correctly when the plaque is flipped over.
• Single-color print — set every color to the same filament. Raised text is still visible from shadow contrast alone.