Minimalist Clock

Model Introduction
This is a minimalist square wall clock dial model, suitable for use with common quartz clock movements. The front of the dial has raised hour markers, the back has reserved space for the movement, and it features a hidden gourd-shaped hanging hole structure to reduce left-right and front-back swinging when hung on a nail or hook

Model Dimensions

• Overall dimensions: approximately 147.5 × 150 × 22 mm
• Dial type: wall-mounted dial
• Front center hole: fits standard quartz clock movement shaft
• Back: reserved movement space + hidden hanging hole structure

Compatible Movement Parameters
Suitable for common A28 / standard shaft quartz clock movements, reference parameters are as follows:

• Movement body dimensions: approximately 56 × 56 × 16 mm
• Total shaft length: approximately 12 mm
• Thread length: approximately 5 mm
• Thread diameter: approximately 7.6 mm
• Dial hole reserved: approximately 8.6 mm
• Recommended dial thickness: movement instructions usually suggest no more than 4 mm

Recommended Hands

• Hour hand: approximately 28 mm
• Minute hand: approximately 44 mm
• Second hand: approximately 36 mm

You can also use short hands of similar size, as long as they do not exceed the dial's scale range

Printing Recommendations

• Material: PLA / PETG are both suitable
• Supports: supports need to be enabled
• Print orientation: maintain default 60-degree angled printing

Installation Instructions

• After printing, insert the quartz clock movement from the back into the reserved space, allowing the shaft to pass through the center hole
• On the front, install the washer, nut, hour hand, minute hand, and second hand in sequence
• The movement can be fixed to the dial with double-sided tape, or by rotating it to snap into the back slot

• The gourd-shaped hanging hole on the back can be used for hanging on small nails, screws, or wall hooks

Note
This model only includes the clock dial body, not the movement, battery, or hands. Movement dimensions may vary slightly among different manufacturers, it is recommended to confirm the movement body and shaft length parameters before purchasing