Search models, users, collections, and posts
Shower Caddy
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 20% infill
Designer
24.7 h
2 plates
Open in Bambu Studio
Boost
22
67
2
0
38
7
Released
Bill of Materials
Bambu Filaments
Select all
Description
The shower caddy model is designed to be hung from a 0.75in diameter showerhead pipe and hold your soaps. The top shelf is for taller bottles, and the bottom shelf is for bars of soap. The design is split to fit a 12 inch build sheet.
- The two channels are made to connect the two side supports to the upper hanger/support.
- There are small rectangular blocks designed to hammer through the holes in the connector and supports.
- If you prefer a loose fit with glue, reduce the width and heighth of those blocks by 0.01inch.
- The shelves snap fit into the supports, but I recommend glue to be sure they don't come apart.
- Make sure the glue is made for whatever filament you use.
- I reccomend PETG and superglue.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)