spray_cap

Hi Makers!  I'm a mechanical engineer & open source developer.  You'll find all my designs are inter-operable and have documentation at OpenLab Project.

Find my content on Youtube to learn about:

• design for 3D printing
• open source hardware
• multidisciplinary engineering

This is a snap-on cap for spray cans or bottles. The fitment is fantastic: one variation proves functional for nearly all metal cans. Three tabs contact the steel lip and interfere to block insertion and removal. Just print the part, then use a utility knife to chamfer these 3 tabs. If the can deviates on the large side, cut a larger chamfer. Cutting more material reduces the required force in assembly. cutting less material makes the cap hold very tightly.

Adjustment: The mating circle features three tabs which hold the cap onto the can.  They interfere with the lip, requiring a pushing force to install the cap.  Each can may deviate a small amount and the tabs can be adjusted.  Use a utility knife to gently trim a fine sliver from each tab, until fitment executes with your desired force.