Search models, users, collections, and posts
Cable clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
66
284
4
0
127
99
Released
Description
Cable clip with ratchet and push-release latch.
The body needs supports enabled, block the supports at the hinge point.
Suggested support options - support pattern: rectilinear grid, pattern spacing: 4 mm, bottom interface layers: 2.
Print, remove the supports, snap the arm into the body and enjoy ;-).
Tested with PLA and PETG.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (4)